To convert your trailer to a Weber coupling, you need the correct connection for your drawbar.

If your drawbar is square, measure the inside to determine the correct size. You then slide this connection into the drawbar.

For round drawbars you must measure the outside diameter. You can do this with a caliper. For very thick round drawbars, measure the inside diameter. The corresponding drawbar connection is available with or without a lock.

The scope of delivery consists of:
- 1 drawbar connection
- 1 drawbar foot
- 1 safety strap
- 1 screw with self-locking nut
- 1 information sticker
- 1 installation manual

For safety reasons, we usually recommend that you have the drawbar connections installed by a professional workshop.

We would like to remind dealers and end users that you are responsible for the entire bicycle trailer system and its proper operation.

You will need two open-end wrenches and/or ring spanners for installation. Sometimes a drill is needed, as well as a hacksaw or pipe cutter.

Available variants of drawbar connections:
- Different sizes for round drawbars
- Crimped square drawbar connection
- Square drawbar connection for Chariot trailers with Y-frame Carry Freedom
- Drawbar connection for Thule trailers with trapezoidal drawbar
- Drawbar connection for Qeridoo trailers built in 2017.